gorenje gs60010w potrebana tabela gresaka

[strule]

pozdrav svima, masina u radu kada dodje do ispiranja upali lampicu 3 i 4 blinka i daje zvucni signal.
lampica ispiranja i lampica susenja blinkaju.

[toce]

Postavi sliku elektronike.

[strule]

da dodam da led za so svjetli

[munja2]

Probaj ovu malu memoriju CSI da obrises i stavis je praznu,sacuvaj sadrzaj negde u folderu...prikaci na masinu i pusti.......posle opet ucitaj sadrzaj i pusti masinu,moze se desiti da otkloni kvar.....

[munja2]

E1
Dishwasher fails to fill with water
If the pressure switch or sensor does not detect that the dishwasher has filled with water inside four minutes the buzzer will sound for thirty seconds and the LED will flash, the drain pump will then be run for sixty seconds and the program aborts.

Check water supply
Check wiring to water valve
Check wiring to pressure switch or sensor
Check water valve
Check pressure sensor or water level sensor
E2
Dishwasher not draining
Dishwasher fails to detect that the water has drained out detected in four minutes, program aborted.

Check water drainage
Check drain pump wiring
Check drain pump
E3
Dishwasher times out when heating
No heat detected in sixty minutes, program aborted.

Check wiring to heater and thermostats
Check water heating element
Check thermostats
E4
Aquastop protection circuit activated
A micro-switch on the Aquastop leak detection system has been switched on for more than two minutes. The dishwasher will shut off the water inlet valve and drain the water aborting the program.

Check for water leaks
Check float in the base of the dishwasher
Check the Aquastop hose if fitted
E5
Not used
E6
Short circuit detected on the temperature sensor
Check water heating sensor wiring
Check temperature sensor
E7
Temperature sensor detected as open circuit
Check water heating sensor wiring
Check temperature sensor